DIY Repair – Gluing with a Repair Kit
Instructions for Gluing PVC Products
(pontoons and other inflatable products and PVC structures)
1. Materials
To carry out the repair, you will need:
-
a PVC patch matched to the product’s material,
-
PVC adhesive (two-component with hardener recommended),
-
degreasing agent (isopropyl alcohol / extraction naphtha),
-
clean lint-free cloth,
-
pressure roller or hard pressing tool,
-
scissors,
-
warm air source (hair dryer or heat gun – low temperature).
2. Degreasing
-
Thoroughly clean the repair area.
-
Remove dust, water, and mechanical dirt.
-
Degrease the surface with a degreasing agent.
-
Leave to dry completely.
⚠ Grease and moisture significantly reduce the durability of the bond.
3. Damage Outline (Patch Outline)
-
Apply the patch so that it overlaps the damage by at least 3–5 cm.
-
Round the corners of the patch.
-
Mark the outline of the gluing area.
4. Applying the Glue
-
Mix the adhesive with the hardener according to the manufacturer’s instructions.
-
Apply a thin, even layer of glue:
-
onto the repaired surface,
-
onto the patch.
-
Waiting Period
-
Wait approx. 10 minutes until the adhesive becomes dry to the touch (tacky state).
Accelerating the Reaction
warm air will accelerate the adhesive action.jpeg
-
You can gently warm the surface with warm air (approx. 40–60°C).
-
Do not overheat the material.
5. Pressing
-
Precisely place the patch onto the designated spot.
-
Press from the center outwards.
-
Use a pressure roller or a hard tool to remove air from under the patch.
Curing Time
-
Do not inflate or load the product for at least 24 hours.
-
Full bond strength: 48–72 hours.
Technical Notes
-
Gluing works best on flat surfaces.
-
Repairs in structural weld areas may be limited.
-
In case of major damage, welding by a specialized service center is recommended.
Leave a Reply